Machining Cutout-Doors page

In This Topic

The Mach.General > Cutout-Doors page of the Catalog/Drawing Properties allows you to turn on machining and provide rebate dimensions for Glass Door Frames.

These Glass Door options are not applied to the DoorMaster LT doors and do not show in 3D (only in machining).

However, the cabinet's Make Glass Door can be used at the same time (which shows the 3D door with a glass panel regardless of any machining) - Click on image to view.

Click to view Cabinet Details - Make Glass Door option

To machine glass door frames for your job, it is important to first check your glass door settings are correct.

Use

The Use checkbox allows you to turn on/off Machine Glass Door Frames.

Rad or Sqr

Radio buttons allow you to select either :-

Rad - is a Radius cabinet door, which makes the Shoulder edit box available.
Sqr - is a square cabinet door.

Tool Diam

Edit box allows to change the diameter of the tool used.

Frame, Beading and Rebate

Width and Depth measurements are available for each.

The diagram explains how the variables apply to the glass Frame and shows two steps, Beading and Rebate.

The Beading variable does not need a value if only one step is required i.e. you would set the beading for both Width and Depth to 0mm.

Cabinet Properties

After entering the correct values applicable to your job on this page, the machining for your glass door needs to be turned on within the Cabinet Properties for each cabinet.

To do this:-

Go to Cabinet Machining > Misc Cutouts page and turn on Cutout for Glass in all Doors under the Various group.
- The cabinet preview will only show Cutout if you are in Wireframe view with the View Machining in 3D option turned on (Click on image)

Cabinet Machining > Misc Cutouts page - Click to view cabinet Preview