The Mach.General > Edge Label page in the Catalog/Drawing Properties provides the ability to mark the sides of a part to be edged.

 

 

If the Use Edge Indicator check box is enabled, this will place a new layer (TextEdge) on the machining DXF along the edges to be edged, as either a :-

• Line - in the example shown below, the line is highlighted.

The diagram explains the edit boxes. These allow you to change the placement and the length. 

OR

• Zigzag - as shown below, this is the default.

The diagram explains the edit boxes. These allow you to change the placement, the length and width of the zigzag.