One way to slope cabinets ends from front to back is to use the settings on the Labour & Construction > Ends+ page.
Step 1
On the Labour & Construction >Top/Bottom page, untick the Top check box to remove the cabinet top.
You will need to manually machine a top for the cabinet, as the top will not slope.
Step 2
On the Labour & Construction > Ends+ page...
- Set the Vertical for both Left and Right Ends to a negative slope height value
- In this example, we have set both to -500mm
- Set the V Offset to the same value as Vertical, except that this needs to be a positive value.
- In this example, we have set both to 500mm
- Set the Horizontal to 2mm larger than the cabinet depth
- In this example, the cabinet Depth on the Cabinet Details > Settings page is 580mm (click on image)
- Therefore the Horizontal is set to 582mm for both.
Step 3
In the example above, on the Labour & Construction > Back page we have removed/unticked the Back
However, you may want to adjust the height of the back to suit i.e. same as above Vertical value (click on image to view example).