In This Topic
    Cabinet Ends
    In This Topic

    In the Catalog/Drawing Properties on the Construction Standard > Ends page, the construction for cabinet ends are set.

    Options for Ends

    Ensuring that your construction method is setup is critical. Incorrect construction setup will lead to incorrect pricing and manufacturing reports. If you are unsure of the setup option, please call our support hotline.

    Corner and angled cabinets are treated as separate sub cabinet groups in CabMaster because customers often use different construction methods for these types of cabinets i.e. a standard floor cabinet is constructed differently than an angled floor corner cabinet.

    Example on an End

    The ends are the sides of the cabinet. You will notice that on the illustration the right end has been surrounded by a border.

    To locate information about any part of the following image, click on the area of interest.

     

     

    The Ends page poses a question for each type of cabinet i.e. how do you construct your ends? Are they :-

    Default Height of End

    Default Heights are automatically recalculated as boxes are checked. The default heights of each cabinet group can be changed for each job/drawing on the Job Setup > Defaults page.

     

    Floor Cabinets

    These options provide the ability to control the construction of ends for Floor cabinets.

    Select the relevant options to :-

    • Extend to Floor
    • Extend to Floor and Below Top
    • Above Bottom
    • Above Bottom and Below Top
    • Below Top

    Kickboard Standard - Cabinet Ends

    The Ends page for Kickboards Standard allows for the ends to made full depth. When selected, the back kickboard will be recessed the selected distance. The example shows ‘Right’ recessed to 150mm.

     

    Tall Cabinets

    These options provide the ability to control the construction of ends for Tall cabinets.

    These are the same as Floor cabinets but provide independent control.

    Select the relevant ends options to :-

    • Extend to Floor
    • Extend to Floor and Below Top
    • Above Bottom
    • Above Bottom and Below Top
    • Below Top

     

    Wall Cabinets

    These options provide the ability to control the construction of ends for Wall cabinets.

    Select the relevant ends options to :-

    • Above Bottom
    • Below Top
    • Above Bottom and Below Top

     

    Mullions

    The default width of the mullion is set here.

    Mullions are the partial divisions that are added as an extra surface to hinge a door, whenever there is not a carcass end or full division to attach the door to.

    The mullion width, if the cabinet has a mullion, can be overridden at Cabinet level on the Labour & Construction > Construction page.

    Setting the position and how the mullions are machined are done on the Mach. Shelf/Mullion > Mullions page.

     

    See Also